Panasonic WJ-HD220

86
SPECIFICATIONS
General
Power Source Required: 120 V AC, 60 Hz
Power Consumption: 45 W
Ambient Operating Temperature: +5 °C - +45 °C (41 °F - 113 °F)
Ambient Operating Humidity: Less than 85 %
Dimensions: 420 mm (W) x 44 mm (H) x 350 mm (D)
16-9/16" (W) x 3-7/16" (H) x 13-3/4" (D)
Weight: 5.2 kg (11.4 lbs.)
Input
Video Input: 1.0 V[p-p]/75 Ω Composite video signal with 75 Ω Automatic Termination / Looping
through (x8)
Audio Input: –10 dB 10 kΩ unbalanced, RCA standard jack
Image Process
Compression System: JPEG
Pixel Rate: 720 x 240 (Effective pixels 672 x 224)
Refresh Rate: 30 FPS maximum
Output
Video Output: 1.0 V[p-p]/75 Ω Composite video signal/Looping through (x8)
Video Output Front Panel: 1.0 V[p-p]/75 Ω Composite video signal (x1)
Audio Output: –10 dB 600 Ω unbalanced, RCA standard jack (x1)
Audio Output Front Panel: –10 dB 600 Ω unbalanced, RCA standard jack (x1)
Spot Monitor Output: 1.0 V[p-p]/75 Ω Composite video signal (x1)
Multiscreen Monitor Output: 1.0 V[p-p]/75 Ω Composite video signal (x1)
Control Port
Alarm/Remote Port: 25-pin Full Pitch D-sub connector (x1)
Alarm Input 1-8, Alarm Reset Input, EXT REC Input, Time Adjust Input, Sequence
Input: Low-active, Non-voltage N.O. Contact, ≥100 ms
Alarm Recovery Output 1, Disk End Status Output, Time Adjust Output,
Warning Output, REC Status Output, Sequence Output: Low-active, Open-collector,
24 VDC 100 mA max.
Alarm Output 1, Play Status Output: Low-active, Open-collector,
12 VDC 100 mA max.
Alarm Output 2: High-active, 12 V 4.7 kΩ
Alarm Recovery Output 2: High-active, 12 V DC 220 Ω
RS-485 (PS
•
Data): 6-conductor modular jack (RJ-11)
RS-232C: 9-pin Full Pitch D-sub connector
10/100BASE-TX Port: 10Base-T and 100Base-TX, 8-conductor modular jack (RJ-45)
Protocol Installed: TCP/IP, HTTP, FTP, SMTP, SNMP, DNS, DDNS
Security: Password-protected
Weight and dimensions shown are approximate.
Specifications are subject to change without notice.