Major Operating Controls and Their Functions
14
(5) HDD bay slots
Up to 9 HDD can be installed (one HDD unit is installed at the
factory).
Note:
• Limiting factors for the RAID5/RAID6 mode.
(6) RAID mode switch [RAID]
Switches the HDD operational mode (Single, RAID5, or
RAID6).
The settings become effective after setting the HDD
operation mode with the [RAID] switch and turning on the
power while holding down the [USE] button to boot up.
(7) Removal knob
Used when replacing the HDD units.
RAID5 mode : The RAID5 mode can be used when
more than three HDDs are installed.
RAID6 mode : The RAID6 mode can be used when
more than four HDDs are installed.
S : SINGLE mode (default)
R5 : RAID5 mode
R6 : RAID6 mode
Important:
• The HDD operation mode cannot be changed once the
system is operating. Recorded data may not be read correctly
when the mode is changed after the system is operating.
ND400_Basic.book 14 ページ ２００８年４月８日 火曜日 午後３時５９分
To Next Page
Loading...
