47
Function
08 SPECIAL TRAY 2 Selects the paper tray to use for special paper. 1:NONE
1:NONE / 2:TRAY-1 / 3:TRAY-2 / 4:TRAY-3 /
5:TRAY-4 / 6:BYPASS
(Only available when optional TRAY-2 and 3/4
are installed. See page 59)
09 KEY/TOUCH BEEP Selects the default key sound level. 2:SOFT
1:OFF / 2:SOFT / 3:LOUD
10 BYPASS SET BEEP Selects whether to sound a Beep when paper is 1:INVALID
set on the Sheet Bypass.
1:INVALID / 2:VALID
11 ORIG.SET BEEP ADF Selects whether to sound a Beep when paper is 2:VALID
placed on the ADF.
1:INVALID / 2:VALID
12 PAPER OUT ROTATE
Machine will automatically rotate the image to
1:OFF
accommodate the orientation of the paper in another
Tray and print when the selected Tray is empty.
1:OFF / 2:ON
13 DEPT. COUNTER MODE Monitors the copy usage of each department. Consult your
1:TOTAL COUNTER authorized
2:DEPT. COUNTER service provider
3:DEPT. COUNTER LIST
17 DATE & TIME Sets the date and time.
(Day, Month, Year, Time)
Input the date and time with Cursor Keys and
Keypad.
19 IP ADDRESS (DHCP)
*
1,
*
2
Displays the IP Address which was reserved by
DHCP server.
20 SUBNET MASK(DHCP)
*
1,
*
2
Displays the Subnet Mask Address which was
reserved by DHCP server.
21 DEF. G/W IP(DHCP)
*
1,
*
2
Displays the Gateway IP Address which was
reserved by DHCP server.
22 DHCP DEFAULT
∗
3
Selects whether to enable the DHCP. 2:VALID
1:INVALID / 2:VALID
23 DNS SERVER ADDR.
∗
2
Selects whether to enable the DNS Server, and 2:VALID
sets its settings for Internet Fax/Email Function.
1:INVALID
2:VALID
<Sub Function>
1:HOST NAME / 2:DOMAIN NAME /
3:PRI. DNS SERVER (IP ADDRESS1) /
4:SEC. DNS SERVER (IP ADDRESS2)
24 MAC ADDRESS Indicates the MAC address.
■ General Settings (For Key Operator) (Continued)
No.
Modes Function
Initial
Setting
NOTE ∗1When setting other than DHCP server Network settings, Parameter No. “22 DHCP DEFAULT” should be set to “INVALID”
first, then setup Parameters No.19 to 21.
∗2 When Parameters No. 19 to 23 (except 22) and No. 23 are set, cycle the power by turning the Power Switch on the Right
Side of the machine OFF and ON.
∗3When not connecting to LAN, the DHCP setting should be in the OFF position. When the DHCP setting is on ON, and the
machine is in the Shutdown Mode, Fax reception will not be accepted.
<to be continued>
To Next Page
Loading...
Need help?
General
