30
Configure the multi-screen settings [Multi-screen]
Assign cameras to be displayed on a multi-screen [Multi-screen setup]
The cameras to be used for the multi-screen display can be registered on this page.
Refer to the operating instructions (PDF) for descriptions of how to display images on a multi-screen.
The following cameras are applicable for the multi-screen display. (as of April 2008)
WV-NF284 series, WV-NS202 series, WV-NP240 series, WV-NP1000 series, WV-NW470S series, WV-NP472, WV-
NS320 series, WV-NW484S series, WV-NS950 series, WV-NW960 series
[IP address]
Enter the IP address or the host name of the camera to
be used for the multi-screen. 4 cameras can be regis-
tered as a group and up to 4 groups (16 cameras) can
be registered.
When the HTTP port number for the camera had
been changed, enter as follows: Enter "IP address
of the camera:port number", for example:
Example when entering an IPv4 address:
192.168.0.10: 8080
Example when entering an IPv6 address:
[2001:db8:0:0:0:0:0:1]:8080
Number of characters for the IP address: 1 - 128
characters
Notes:
• When using the host name, it is necessary to config-
ure the DNS settings of the PC to be used for the
multi-screen display. (☞ page 46)
• When using Windows XP SP2, enter an IPv4
address. Images from the camera may not be dis-
played correctly if an IPv6 address is entered.
[Camera title]
Enter the title of the camera. The entered camera title
will be displayed on a multi-screen.
Number of characters for the camera title: 0 - 20
characters
Note:
When selecting a 16 split-screen, some characters
of the camera title to be displayed may not be dis-
played.
To Next Page
Loading...
