Panasonic WV-NF302 - Configuring Priority Stream Settings [System]; Priority Stream Activation Control; Destination IP Addresses (IPv4;IPv6); Stream Type Selection (MPEG-4;JPEG)

41
Configure the settings relating to the priority stream [System]
Click the [System] tab on the "User mng." page. (☞ pages 4 and 5: How to display/operate the setup menu)
Configuring the following settings for the priority stream (to transmit images to multiple users without changing image
quality).
■ Priority stream
[Activation]
Select "On" or "Off" to determine whether or not to use
the priority stream.
On: Use the priority stream.
Off: Do not use the priority stream.
Default: Off
Note:
When "On" is selected for "Activation" of "Priority
stream", number of users who can access the cam-
era will be limited.
[Destination IP address (IPv4)]
Enter the destination IPv4 address.
[Destination IP address (IPv6)]
Enter the destination IPv6 address.
[Stream type]
Select "MPEG-4" or "JPEG".
MPEG-4: MPEG-4 images will be transmitted.
JPEG: JPEG images will be transmitted.
Default: JPEG
[Refresh interval*]
Select the refresh interval from the following.
This setting is validated only when "JPEG" is selected
for "Stream type".
Note:
The refresh interval may be longer than the set
value when any value with an asterisk (*) on the
right is selected.
0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps/2 fps/3 fps/5 fps/
6 fps*/10 fps*/15 fps*/30 fps*
Default: 1 ftp
[Image capture size]
Select the image capture size from the following.
QVGA/VGA/1 280 x 960
Default: VGA