Panasonic WV-NF302 - Configuring SNMP Settings [SNMP]; SNMP Contact Information Entry; SNMP Community Name Configuration; SNMP System Name and Location Setup

49
Configure the settings relating to SNMP [SNMP]
Click the [SNMP] tab on the "Network" page. (☞ pages 4 and 5: How to display/operate the setup menu)
The settings relating to SNMP can be configured on this page. It is possible to check the status of the camera by
connecting to the SNMP manager. When using the SNMP function, contact the network administrator.
[Community]
Enter the community name to be monitored.
Number of characters for "Community": 0 - 32 char-
acters
Default: None (blank)
Important:
When using the SNMP function, it is necessary to
enter the community name. When no community
name is entered, the SNMP function will not work.
[System name]
Enter a system name to be used to manage the camera
with the SNMP function.
Number of characters for "System name": 0 - 32
characters
Default: None (blank)
[Location]
Enter the name of the location where the camera is
installed.
Number of characters for "Location": 0 - 32 charac-
ters
Default: None (blank)
[Contact]
Enter the mail address or the phone number of the
SNMP manager.
Number of characters for "Contact": 0 - 255 charac-
ters
Default: None (blank)