48
Set mask areas
When "Off" is selected for "Super Dynamic" and "Back light compensation(BLC)", it is possible to compensate for
backlight by masking brighter areas.
Step1
Display the "Image adjust" setup menu. (☞ page 44)
Step 2
Click the [Start] button of "Mask area".
→ Borders will appear and the image displayed on the
[Image/Privacy] tab will be divided into 48 (6x8).
Step 3
Click the divided areas to be masked.
→ The clicked areas will be masked and will become
white. To cancel masking, click the area again.
Step 4
Click the [End] button after completing masking areas.
→ The borders on the image displayed on the
[Image/Privacy] tab will disappear.
Note:
• When the [Reset] button is clicked, masking for all
the masked areas will be canceled.
To Next Page
Loading...
