Panasonic WV-NW502S - Server Settings; Mail Server Configuration

69
Configure the settings of the servers [Server]
[SMTP server address]
Enter the IP address or the host name of the SMTP
server used to send e-mails.
Available number of characters: 1 - 128 characters
[SMTP port]
Enter the port number to which e-mails are sent.
Available port number: 1 - 65 535
Default: 25
[POP server address]
When "POP before SMTP" is selected for "Type", enter
the IP address or the host name of the POP server.
Available number of characters: 1 - 128 characters
Important:
• When entering the host name for "SMTP server
address" or "POP server address", it is necessary to
configure the DNS settings on the [Network] tab of
the "Network" page. (☞ page 73)
[Authentication]
• Type
Select the authentication method to send e-mails from
the following.
None: It is not necessary to clear any authentication to
send e-mails.
POP before SMTP: It is necessary to first clear the
POP server authentication to use the SMTP server
to send e-mails.
SMTP: It is necessary to clear the SMTP server authen-
tication to send e-mails.
Default: None
Note:
• When you don't know the authentication method to
send e-mails, refer to the network administrator.
• User name
Enter the user name to access the server.
Available number of characters: 0 - 32 characters
• Password
Enter the password to access the server.
Available number of characters: 0 - 32 characters
[Sender's mail address]
Enter the mail address of a sender.
The entered mail address will be displayed in the "From"
(sender) line of the sent mails.
Available number of characters: 3 - 128 characters
The settings relating to the mail server, the FTP server and the NTP server can be configured on this page.
The "Server" page has 3 tabs; the [Mail] tab, the [FTP] tab and the [NTP] tab.
Configure the settings relating to the mail server [Mail]
Click the [Mail] tab on the "Server" page. (☞ pages 20 and 21: How to display/operate the setup menu)
The settings relating to the mail server used to send the alarm mail can be configured on this page.
Important:
• When a terminal that receives e-mails is not compatible with UTF-8 encode, it is impossible to receive alarm
mails correctly.