17
ANetwork connector (RJ45)
Connect an Ethernet cable (category 5e or better) to the network connector.
IMPORTANT:
Use all 4 pairs (8 pins) of the Ethernet cable.
Make sure that the PoE device in use is compliant with IEEE802.3af standard.
When connecting both the 12 V DC power supply and the PoE device for power supply, 12V
DC will be used for power supply.
When the Ethernet cable is disconnected once, reconnect the cable after around 2seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
ANetwork connector (RJ45)
B12 V DC power supply terminal
FMONITOR OUT terminal
(factory shipment: NTSC monitor)
CAudio input connector
DAudio output connector
EEXT I/O terminals
■Terminals
* This illustration represents WV-S2131L
To Next Page
Loading...
