Panasonic WV-SC385PJ - Precautions for Installation

Precautions for installation
Installing place
Contact your dealer for assistance if you are unsure of an
appropriate place in your particular environment.
 • Makesurethatthe installationareaisstrongenough
to hold this product, such as a concrete ceiling.
 • Whentheinstallationareaisnotstrongenough,rein-
force and strengthen it or use an optional mount
bracket (WV-Q155S, WV-Q155C or WV-Q105).
 • Whentheproductisinstalled on awall,usethe wall
mount bracket WV-Q154C or WV-Q154S (option).
 • Whenusinganoutdoorhousingtoinstalltheproduct
on the ceiling, use the inner cover (provided with
WV-Q157 or other optional mount brackets). That can
avoid the shape of the camera from reflecting on
images.
 • The optional mount brackets for WV-NS202A
(WV-Q150C, WV-Q150S, WV-Q151C, WV-Q151S,
WV-Q152C, WV-Q152S) cannot be used with this
product.
Do not place this product in the following places:
 • Locations where it may get wet from rain or water
splash
 • Locationswhereachemicalagentisusedsuchasa
swimming pool
 • Locations subject to humidity, dust, steam and oil
smoke
 • Locationsinaspecificenvironmentwhereasolventor
a flammable atmosphere exists
 • Locationswherearadiation,an X-ray,a strongradio
wave or a strong magnetic field is generated
 • Locationswherecorrosivegasisproduced,locations
where it may be damaged by briny air such as sea-
shores
 • Locationswherethetemperatureisnotwithin−10°C
to +50 °C {14 °F to 122 °F}.
 • Locations subject to vibrations (This product is not
designed for on-vehicle use.)
 • Locations subject to condensation as the result of
severe changes in temperature (In case of installing
the camera in such locations, the dome cover may
become foggy or condensation may be caused on
the cover.)
Procure fixing screws separately.
The screws that secure this product are not supplied.
Prepare them according to the material and strength of
the area where the product is to be installed.
Screw tightening
 • The screws and bolts must be tightened with an
appropriate tightening torque according to the materi-
al and strength of the installation area.
 • Donotuseanimpactdriver.Useofanimpactdriver
may damage the screws or cause tightening exces-
sively.
 • Whenascrewistightened,makethescrewataright
angle to the surface. After tightening the screws or
bolts, perform visual check to ensure tightening is
enough and there is no backlash.
Be sure to remove this product if it is not in use.
Radio disturbance
When this product is used near TV/radio antenna, strong
electric field or magnetic field (near a motor, a transformer
or a power line), images may be distorted and noise
sound may be produced.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with IEEE802.3af
standard.
Router
When connecting this product to the Internet, use a
broadband router with the port forwarding function (NAT,
IP masquerade).
Refer to the Operating Instructions (PDF) for further infor-
mation about the port forwarding function.
Time & date setting
It is necessary to set the time & date before putting this
product into operation. Refer to the Operating Instructions
(PDF) on the provided CD-ROM for descriptions of how to
perform the settings.
Panasonic assumes no responsibility for injuries or property damage resulting from failures arising out of
improper installation or operation inconsistent with this documentation.
12