[VIQS] - [H.264(2)]
Select “On” or “Off” to determine whether or not to activate the VIQS function for the transmitted (H.264(2))
images.
• Default: Off
IMPORTANT
• Configure VIQS again if the setting for “Image capture mode” of the [JPEG/H.264] tab or
“Upside-down” of the [Basic] tab is changed after the VIQS is set to “On”.
Note
• Refer to page 119 for setting procedure of the VIQS area.
118 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
