EasyManua.ls Logo

Panasonic WV-SFV110 - Page 14

Panasonic WV-SFV110
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
Before installation
When installing the product to a ceiling or
wall, either directly mount it to a wall or
ceiling, or install it using a mount bracket
(accessory).
Anchor bolts and screws used to mount
the camera on the ceiling or wall are not
supplied. Prepare anchor bolts and screws
that match the structure and materials of
the installation location and satisfy the per-
formance and reliability specifications
shown below.
Required screws: M4 (3 pcs.)
Minimum pull-out strength: 196 N {44 lbf}
(per 1 pc.) (When securing the camera to a
wall or ceiling using the mount bracket,
make sure to use ø10 mm flat washers.)
Screw tightening
The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
Do not use an impact driver. Use of an
impact driver may damage the screws or
cause tightening excessively.
When a screw is tightened, make the
screw at a right angle to the surface. After
tightening the screws or bolts, perform
checks to ensure that the tightening is
sufficient enough so that there is no
movement or looseness.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.
Take notice of humidity
Install this product when the humidity is low. If
this product is installed during rainfall or at a
high humidity, the inside may be exposed to
moisture and the dome cover may become
foggy.
Radio disturbance
When this product is used near TV/radio
antenna, strong electric field or magnetic field
(near a motor, a transformer or a power line),
images may be distorted and noise may be
produced.
Router
When connecting this product to the Internet,
use a broadband router with the port forward-
ing function (NAT, IP masquerade).
Refer to the operating instructions on the pro-
vided CD-ROM for further information about
the port forwarding function.
Time & date setting
It is necessary to set the time & date before
putting this product into operation. Refer to the
operating instructions on the provided
CD-ROM for descriptions of how to perform
the settings.
Make sure to remove this product if it will
no longer be used.

Other manuals for Panasonic WV-SFV110

Related product manuals