15
Parts and functions
Enclosure
Dome cover
WV
SFV130-
SD memory card slot
Network cable
Built-in
microphone
Lens
INITIAL SET button
SD CARD indicator
LINK indicator
ACT indicator
Lens body
About the initial set button
Follow the steps below to initialize the network camera.
ATurn off the power of the camera.(Disconnect the Ethernet cable from the camera.)
BTurn on the power of the camera while holding down the INITIAL SET button, and then keep
holding down the button for 10-15 seconds. In about 2 minutes later, the camera will start up
and the settings including the network settings will be initialized.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Note that the CRT key (SSL encryption key) used for the HTTPS protocol will not be initial-
ized.
• Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
To Next Page
Loading...
