For mounting on wall
z Put the tripod mount base on the bottom of the camera.
Secure the safety wire lug for wall (accessory) to the camera mount screw hole with the wire
lug fixing screw (accessory).
Important:
• Be sure to use theprovided fixing screws
for the safety wire lug and the removed
screws for the camera mount base.
When using different length screws, it may
damage the camera or cause the camera
to fall.
(Recommended tightening torque:
0.39 N·m {0.29 lbf·ft})
x Engage the safety wire with the wire engaging hole.
q Pass the ring part of the safety wire
through the wire engaging hole.
w Pass the other end of the safety wire
through the ring part of the safety wire.
To Next Page
Loading...
