Panasonic WV-SP306

21
Installation
Connect the safety wire
The following is an example of safety wire connection.
Important:
 • Besuretoinstallthesafetywire.Askyourdealerforinstallation.
For mounting on ceiling
z Remove the tripod mount base on the top of
the camera.
x Align the tripod mount base with the safety wire
plate for ceiling (accessory) and attach them to
the camera with the mounting screws.
Important:
 • Use the detached mounting screws to attach the tripod mount base. When using different
length screws, it may damage the camera or cause the camera to fall.
(Recommended tightening torque: 0.39 N·m {0.29 lbf·ft})
c Engage the safety wires (2 pieces) with the wire engaging holes (front and rear) respectively.
T
Mounting screws
Tripod mount
base
Safety wire plate
for ceiling
(accessory)
Wire engaging
hole (front)
Wire engaging
hole (rear)
q Pass the ring part of the safety wire
through the wire engaging hole.
w Pass the other end of the safety wire
through the ring part of the safety wire.
Wire engaging hole
Safety wire