Panasonic WV-SP306

26
v Connect external devices to the EXT I/O terminal.
When connecting an external device, remove 9 mm - 10 mm
{11/32" - 13/32"} of the outer jacket of the cable and twist the
cable core to prevent the short circuit first.
Specification of cable (wire): 22 AWG - 28 AWG
Single core, twisted
 • Check whether the stripped part of the
wire is not exposed and is securely con-
nected.
* DAY/NIGHT IN is only for WV-SP306.
Important:
 • Do notconnect2wiresormore directlytoaterminal. When it isnecessarytoconnect2 or
more wires, use a splitter.
 • Connectanexternaldevicewithverifyingthattheratingsarewithinthespecificationsabove.
 • WhenusingtheEXTI/Oterminalsastheoutputterminals,ensuretheydonotcausesignalcol-
lision with external signals.
<Ratings>
 • ALARMOUT,AUXOUT
Output specification: Open collector output (maximum applied voltage: 20 V DC)
Open: 4 V - 5 V DC by internal pull-up
Close: Output voltage 1 V DC or less (50 mA or less)
 • ALARMIN/DAY/NIGHTIN*
Input specification: No-voltage make contact input (4 V - 5 V DC, internally pulled up)
OFF: Open or 4 V - 5 V DC
ON: Make contact with GND (required drive current: 1 mA or more)
* DAY/NIGHT IN is only for WV-SP306.
b Connect a LAN cable (category 5 or better,
straight, STP*) to the network connector on the
rear of the camera.
* PAL models only
n Connect the power supply.
Important:
 • The12VDCpowersupplyshallbeinsulatedfromthe commercial AC power.
 • Theoperatingsoundmightbeheardwhenthepoweristurnedon,howeveritdoesnotindi-
cate any malfunction.
Strip range
9 mm - 10 mm
{11/32" - 13/32"}
4 3 2 1
r GND
e AUX OUT
w ALARM OUT
q ALARM IN / DAY/NIGHT IN*
POWER
10BASE T/100BASE-TX
AUDIO OUT MIC/LINE IN
EXT I/O
MONITOR OUT
ACT LINK
12V = IN
GND 4 3 2 1
INITIAL
SET
SD CARD/ABF
ALARM IN 1/DAY/NIGHT IN
AUX OUT
ALARM OUT
LAN cable
(This illustration represents
WV-SP306.)