Panasonic WV-SP306

30
z Start the Panasonic IP setting software.
x Click the [IP setting] button after selecting the
MAC address/IP address of the camera to be
configured.
Note:
 • When using a DHCP server, the IP address
assigned to the camera can be displayed by
clicking the [Refresh] button of the IP setting
software.
 • WhenaduplicateIPaddressisused,thecorre-
sponding MAC address/IP address will be dis-
played shaded.
c Complete each network setup item and click
the [Apply] button.
Note:
 • WhenusingaDHCPserver,itispossibletoset
"DNS" to "AUTO".
Important:
 • Itmaytakeforaround2minutestocompletetouploadthesettingstothecameraafterclicking
the [Apply] button. The settings may be invalidated when the 12 V DC power supply is cut or
when the LAN cable is disconnected before completing the upload. In this case, perform the
settings again.
 • Whenusingafirewall(includingsoftware),allowaccesstoallUDPports.