It is possible to adjust the angular field of view using the extra optical zoom function.
• : Click this button to adjust the zoom ratio to the “Wide” side.
• : Click this button to set the zoom ratio to x1.0.
• : Click this button to adjust the zoom ratio to the “Tele” side.
• : Click these buttons to adjust the horizontal/vertical position of the image after zooming.
Note
• When “2 mega pixel [16:9](30fps mode)
” or “2 mega pixel [16:9](60fps
mode)” is selected for “Image capture mode”, the maximum zoom ratio of the extra optical zoom
becomes x3.0.
• When “2 mega pixel [4:3](30fps mode)” or “3 mega pixel [4:3](30fps mode)” is selected for “Image
capture mode”, the maximum zoom ratio of the extra optical zoom becomes x2.5.
• When “1.3 mega pixel [16:9](30fps mode)” or “1.3 mega pixel [16:9](60fps mode)” or “1.3 mega pixel
[4:3](30fps mode)” or “2 mega pixel [16:9](30fps mode)
”is selected for “Image capture
mode”, the maximum zoom ratio of the extra optical zoom becomes x2.0.
IMPORTANT
• The positions will move out of alignment if extra optical zoom settings are configured when the mask
area (®page 96), privacy zone (®page 103), VMD area (®page 126), VIQS area (®page 107), or
cropping area (®page 137) is configured. To prevent this, perform the setting for the extra optical
zoom function before other settings.
102 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
