13.3 Change the AUX name [Alarm]
Click the [Alarm] tab on the “Alarm” page. (®page 42, page 44)
The names of “AUX”, “Open” and “Close” on the “Live” page can be changed.
AUX title
[AUX (Up to 10 characters)]
Enter the name for “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: AUX
[Open (Up to 5 characters)]
Enter the name for “Open” of “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: Open
[Close (Up to 5 characters)]
Enter the name for “Close” of “AUX” on the “Live” page.
• Unavailable characters: " &
• Default: Close
Note
• When AUX setting is not available, AUX name cannot be changed.
• AUX is a camera terminal that allows users to operate (Open/Close) arbitrarily from the “Live” page.
For example, an operator can remotely control lights in a place where the camera is installed by
connecting the terminal to the light controller.
13.4 Configure the settings relating to the camera
action on alarm occurrence [Alarm]
Click the [Alarm] tab on the “Alarm” page. (®page 42, page 44)
120 Operating Instructions
13 Configure the alarm settings [Alarm]
To Next Page
Loading...
