IMPORTANT
• When “On” is selected for “Adaptive black stretch”, noise in the darker parts may be increased, and
parts around borders between the darker parts and the brighter parts may become darker/brighter than
the other darker/brighter parts.
Note
• When “On(High)” or “On(Normal)” is selected for “Super Dynamic(SD)” or “Wide dynamic range
(WDR)”, “Adaptive black stretch” is unavailable.
[Back light compensation (BLC)]
Select “On” or “Off” to determine whether or not to activate the back light compensation (BLC) function. When
“On(High)” or “On(Normal)” is selected for “Super Dynamic(SD)” or “Wide dynamic range (WDR)”, this setting
is unavailable.
The back light compensation function can compensate back light by setting mask areas on brighter parts of
images.
• On: Mask areas will be set automatically.
• Off: Mask areas will not be set automatically. It is necessary to set them manually.
• Default: Off
[Mask area]
When “Off” is selected for “Super Dynamic(SD)”, “Wide dynamic range (WDR)” and “Back light compensation
(BLC)”, it is possible to compensate for backlight by masking brighter areas.
Refer to page 96 for information on how to set the mask area.
[Light control mode]
Select the light control mode from the following.
• Outdoor scene: Depending on the brightness level (illuminance), the iris will automatically be controlled
together with the shutter speed adjustment to control light. When shooting a bright subject such as outdoor,
etc., select this parameter. Be aware that flicker may occur when a subject is under fluorescent lighting.
• Indoor scene (50 Hz) / Indoor scene (60 Hz): The shutter speed will automatically be adjusted to prevent
flicker caused by fluorescent light. Select 50 Hz or 60 Hz corresponding to the location where the camera
is in use.
• ELC
: Use shutter speed adjustment to control light.
• Fix shutter:
– When “2 mega pixel [16:9](60fps mode)” or “1.3 mega pixel [16:9](60fps mode)” is selected for “Image
capture mode”:
1/60 Fix, 1/100 Fix, 1/120 Fix, 1/250 Fix, 1/500 Fix, 1/1000 Fix, 1/2000 Fix, 1/4000 Fix, 1/10000 Fix
– When a setting other than “2 mega pixel [16:9](60fps mode)” or “1.3 mega pixel [16:9](60fps mode)”
is selected for “Image capture mode”:
1/30 Fix, 3/100 Fix, 3/120 Fix, 2/100 Fix, 2/120 Fix, 1/100 Fix, 1/120 Fix, 1/250 Fix, 1/500 Fix, 1/1000
Fix, 1/2000 Fix, 1/4000 Fix, 1/10000 Fix
• Default: Outdoor scene
Note
• When a faster shutter speed is selected (up to 1/10000), it is possible to capture a fast moving object
with less blur.
• When a faster shutter speed is selected, the sensitivity will become lower.
• When “On(High)” or “On(Normal)” is selected for “Super Dynamic(SD)” or “Wide dynamic range
(WDR)”, “Fix shutter” and “ELC
” are not available. To configure “Fix
shutter” and “ELC
”, set “Super Dynamic(SD)” or “Wide dynamic range
(WDR)” to “Off”.
Operating Instructions 91
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
