If further adjustments are required, repeat from step 2.
Note
• “Audio detection” can only be used when “Mic input” or “Interactive(Full-duplex)” is selected for “Audio
transmission/reception” on the [Audio] tab of the “Image/Audio” page. (®page 120)
• Noise or other unwanted sound from the surrounding area may be mistakenly detected.
• Only the volume of the sound determines whether sound is detected or not, the type of sound does
not matter.
13.7 Configuration of the settings relating to alarm
notification [Notification]
Click the [Notification] tab on the “Alarm” page. (®page 41, page 43)
The settings relating to Panasonic alarm protocol and HTTP alarm notification can be configured in this section.
140 Operating Instructions
13 Configure the alarm settings [Alarm]
To Next Page
Loading...
