The description below is the configuration of the priority stream that can transmit images without deteriorating
the image quality and refresh interval even when multiple users access concurrently.
Priority stream
[Activation]
Select “On” or “Off” to determine whether or not to use the priority stream.
• Default: Off
Note
• When “On” is selected for “Activation” of “Priority stream”, number of users who can access the camera
may be limited.
[Destination IP address(1)]
Enter the first destination IP address.
[Destination IP address(2)]
Enter the second destination IP address.
[Stream type]
Select “JPEG(1)”, “JPEG(2)”, “JPEG(3)”, “H.264(1)”, “H.264(2)”, “H.264(3)”, or “H.264(4)”.
• JPEG(1): JPEG(1) images will be transmitted.
• JPEG(2): JPEG(2) images will be transmitted.
• JPEG(3): JPEG(3) images will be transmitted.
• H.264(1): H.264(1) images will be transmitted.
• H.264(2): H.264(2) images will be transmitted.
• H.264(3): H.264(3) images will be transmitted.
• H.264(4): H.264(4) images will be transmitted.
• Default: JPEG(1)
Note
• When “Best effort” is selected for “Transmission priority” of “H.264”, bit rate will vary between the
maximum and minimum rates while images are being transmitted.
[Refresh interval*]
Select the refresh interval from the following.
This setting is validated only when “JPEG(1)”, “JPEG(2)”, or “JPEG(3)” is selected for “Stream type”.
0.1fps/ 0.2fps/ 0.33fps/ 0.5fps/ 1fps/ 2fps/ 3fps/ 5fps/ 6fps*/ 10fps*/ 12fps*/ 15fps*/ 30fps*
• Default: 1fps
Operating Instructions 151
15 Configure the settings relating to the authentication [User mng.]
To Next Page
Loading...
