Note
• The following are the camera operations that can be learned.
– Start position operations
pan/tilt/zoom/focus position/brightness
– Camera operations
pan/tilt/zoom/focus position/brightness/moving the preset position
• The auto focus function cannot be used when performing patrol operations. As a characteristic of zoom
lenses, when images are zoomed up from the “Wide” side, they may become blurred. When learning
zoom operations, starting from the “Tele” side will reduce blurring.
• The operational range of patrol is from horizontal to directly underneath the camera. Digital flip function
cannot be used.
[Zoom] buttons, [Focus] buttons, [Brightness] buttons, Control pad/buttons and [Go] button
Refer to page 12 for descriptions of how to operate these buttons/pad.
[Close] button
Click this button to close the “Patrol” setup menu.
11.6.7 Configure the settings relating to auto track (“Auto track”
setup menu) (SW396/SC386)
Click the [Setup>>] button of “Auto track” on the [Image/Position] tab of the “Image/Audio” page (®page 98).
120 Operating Instructions
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
