Panasonic WX-CC411 - Page 34

34
Operating procedures
 To release Speed Team operation, touch the
[OFF] button for [Speed Team] on the screen in
step 2.
p In the All-In-One Headsets or Belt Packs, the
“SPEED TEAM OFF” voice prompt is heard from the
earphones, and normal operation is restored.
p In Speed Team mode, it is not possible to talk with
customers at the order posts.
p When talking is attempted from an All-In-One Headset
or Belt Pack, the “Operation not allowed” voice prompt
is heard from the earphone.
Note
Cross Beep (WX-CC412 only)
“Cross Beep” is a function that enables a beep tone to be
heard from the All-In-One Headsets or Belt Packs when a
customer approaches the order post of the other lane.
 Touch (Quick Operation button) on the
touch panel, and then touch the [Common]
button.
 Touch the [ON] button for [Cross Beep] to
enable Cross Beep operation.
p To release Cross Beep, touch the [OFF] button.
OFF:
If lane A has been selected, beep tone A will be heard when
a vehicle in lane A is detected.
However, beep tone B will not be heard even when a vehicle
in lane B has been detected.
ON:
If lane A has been selected, beep tone A will be heard when
a vehicle in lane A is detected.
Furthermore, beep tone B is heard at a low volume level
even when a vehicle in lane B has been detected.
When vehicles have been detected in both lanes, beep tone
A and beep tone B, which are heard at a low volume level,
will be heard alternately.
Cross
Beep
Vehicle detector All-In-One Headset or Belt Pack
Lane A is
ON
Lane B is
ON
AB
OFF
{
–
Beep A
–
–
{
–
Beep B
{{
Beep A Beep B
ON
{
–
Beep A Low level Beep A
–
{
Low level Beep B Beep B
{{
Beep A +
Low level Beep B
Beep B +
Low level Beep A