12
PA N D O R A S M A R T P R O V 3
SYSTEM FUNCTIONS AND MODES
Security mode
The system confirms arming with
1х
sound and 1х
light signals. When the system is armed, the
system monitors security zones with separated warning and alarm level of triggering:
•Warning mode - this mode activates when there is a slight impact on the shock sensor or additional
senor. It is accompanied with
1х
light and 3х
sound
signals;
•Alarm mode - this mode activates when a sensor or one of the security zones is triggered. It is
accompanied with
30 sec.
light and 30 sec. sound signals. The alarm signals can be
canceled by an arming or disarming command. If one of the security zones is triggered the system:
•records this event in its non-volatile memory;
•activates the alarm or warning mode;
•informs an owner by all available means;
•blocks the engine (in accordance with the settings and connections).
• If one of the security zones is opened at the moment of arming, the system will produce
4х
sound and 4х
light warning signals.
If one of the security zones fails, the system will forcibly turn off this zone. If a switch triggers
more than 9 times in a row, it will be disabled until the next arming. The shock/tilt/motion sensor is
temporarily deactivated (15 sec.) if it has been triggered more than 3 times in a row.
The system confirms disarming with
2х
sound and 2х light signals. The system deactivate
engine blocking (if the immobilizer function and additional blocking are not used). If there were alarm
events during the armed period, the system will produce
4х
sound and 4х
light warning
signals. The system continues to display all zones when it is disarmed, but the information is not saved
in the memory.
Security and monitored zones
•Interior temperature (status)
•Engine temperature (status)
•Outside temperature (status)*
•Voltage of the on-board circuits (status)
•Engine operation control - RPM (status)
•Heater operating control (status)
•Fuel level (status)
•Parking (automatic gearbox) /Handbrake (manual gearbox) status