16
PA N D O R A S M A R T P R O V 3
If the system cannot detect an authorization device, the base unit will perform a delayed engine
blocking. The siren will play the ‘Engine blocking warning’ ringtone before blocking. The engine will
be blocked immediately or at the time the car starts moving, it depends on the system settings. When
an authorization device appears in the coverage zone, the system will exit blocking mode and will
continue to work in normal mode.
!
THIS MODE IS DISABLED BY DEFAULT. THIS MODE CAN BE SET ONLY BY A PROFESSIONAL SPECIALIST.
Multi-button code immobilizer (pin-to-drive)
Multi-button code immobilizer (pin-to-drive) is a function that allows disarming, disabling blocking
and controlling service mode and time channels using original vehicle controls (button, lever or pedal)
and a pre-programmed PIN-code (the “Immobilizer PIN-code”).
AN EXAMPLE OF USING THE FUNCTION
•Turn on the ignition to disable engine blocking or enable service mode, turning on the ignition is not
required if you want to disarm the system or control time channels.
•Enter the “Immobilizer PIN-code”. Press a programmed button/lever/pedal the number of times
equals to the first digit. Pauses between presses should not exceed 1 second. More than 1 second
pause will be interpreted as the start of the next digit input. The immobilizer code can consist max
of 4 digits from 1 to 9.
•The system will confirm the correct input by a sound signal of the beeper and a programmed
function will be performed.
!
THIS MODE IS DISABLED BY DEFAULT. THIS MODE CAN BE SET ONLY BY A PROFESSIONAL SPECIALIST.
Checking the number of paired devices
The number of paired radio tags/mobile device can be checked by the number of flashes of the LED
indicator. The number of tags/mobile device can be checked when switching on the ignition (the system must
be disarmed). The number of green flashes will indicate the number of paired radio tags, a following red flash
will indicate a paired mobile device.
You can also check the number of paired radio tags/mobile device by taking off and putting back on
battery terminal. The system will emit short sound signals from a siren
:
•First series of the siren signals
– indicates the number of paired radio tags;
•The second long signal
– after a pause of 2 seconds indicates a paired mobile devices.
To Next Page
Loading...
Need help?
General
