8
PA N D O R A S M A R T P R O V 3
Base unit
Built-in GSM modem (2G/3G/4G LTE) provides a connection with our online-service pandora-on.
com and mobile applications (Pandora Online/Pandora Pro), allows to control the system by a phone
using DTMF-commands, voice and SMS notifications, automatic date and time detection. The modem
operates in a mobile network using the built-in SIM-chip or/and a nano-SIM.
Built-in SIM-chip (SIM1 of the system) is and integrated SIM-card chip that it used to work with the
built-in GSM modem. The built-in SIM-chip has a tariff plan for Russia (phone number is written on the
“Owner’s personal card”).
Built-in slot for a nano-SIM (SIM2 of the system) is used for owner’s SIM-card (nano-SIM) If both
the SIM-chip and SIM-card are used in the system, there is a function that allows to automatically switch
between the SIM-chip and the SIM-card if there is no internet connection
!
it is required to install an additional sim-Card in the nano-sim slot for the automatiC mode. if you install a
SIM-CARD IN THE NANO-SIM SLOT, SET UP THE SIM2 SETTINGS.
Built-in GPS/GLONASS-receiver is designed to determine current location and to automatically
determine UTS date and time.
2.4GHz radio channel, Bluetooth 5.0 protocol (BT5.0) supports up to 14 additional Bluetooth
devices (see the “Additional devices” section), including a mobile phone.
Built-in 3D accelerometer is used to detect shock/motion/tilt including 2 separate zones of shock
sensor (alarm and warning), the system allows to adjust sensitivity of each zone, to use data from the
accelerometer to block the engine and close the central lock on movement.
Temperature sensors allow the system to measure temperature of different zones to send this
information to the mobile apps. The following zones are available: interior temperature – built in sensor
of the main unit, engine temperature – external temperature sensor (see the “System set”), outside
temperature – digital car protocol*.
The system setting allow you to reassign sensor to different zones and use information from
external additional devices (PS-331BT, RHM-03 BT, DMS-100 BT); to implement automatic engine or
engine pre-heater starts and stops by temperature-
To Next Page
Loading...
Need help?
General
