Pantum M7100 Series User Manual

2. SSID cannot be found when network is connected
• Inspectifthepowerswitchofaccesspoint(wirelessrouter)isturnedon.
•
Theprintercannotfind
theSSIDoftheaccesspoint(wirelessrouter)youneedtoconnect,
please check the SSID of access point and try to connect again.
• Everytimewhenthesetupofaccesspoint(wirelessrouter)ischanged,youmustsetupthe
wireless network of printer again.
3. Connection failure
• Pleaseinspectifthesafemodeandpasswordofaccesspoint(wirelessrouter)andprinter
is correct.
• Inspectthewirelessreceivingaroundprinter.Signalreceivingmaybeaffectediftherouter
is away from the printer or there is an obstacle between them.
• Turnthepowerofaccesspoint(wirelessrouter)andprinteroffandthenrestartthemandset
up.
4. The following aspects should be inspected if the printer has problems while they are used
in network:
•
Inspectifthefirewall softwareblockscommunication.Ifthecomputerandprinterare
connected in the same network but they cannot be searched, the communication might be
blockedbyfirewall software.Pleaserefertotheuserguideoffirewall softwaretoturn
firewall
off and then try to search the printer again.
• InspectiftheIPaddressassignmentofprinteriscorrect.YoucaninspectIPaddressby
printing the network setup information page of printer out.
Note:•Pleaserefertotheuserguideorconsultthemanufacturerforinformation related
to access point (wireless router).
• Please refer to the following steps to check if printer and computer are in the same
network:
1) Select "Command prompt" as shown below.
a. Windows 8/10 system：
Select "Search" button in the Start Menu and input "Command
prompt"in search bar，
then press the "Enter”button in the keyboard.
b.
Windows 7/Vista/XP system：click "Start" menu-"All procedures"-"Attachment"-"
Command prompt ".
2) Input ping and your printer IP address in popup window, and press "Enter" button.
For example: ping XXX.XXX.XXX.XXX(“XXX.XXX.XXX.XXX” is printer IP address)
3) If RTT is indicated in the window, that is to say your printer and computer are in the
same network.If RTT is not indicated in the window, please refer to Chapter 5 to reconfigure
the printer wireless network.
56

Pantum M7100 Series Specifications

General

Functionality	Print, Copy, Scan
Print Technology	Laser
Processor Speed	600 MHz
Memory	256 MB
Duplex Printing	Automatic
Scan Type	Flatbed, ADF
Fax Function	No
Paper Input Capacity	250 sheets
Supported Operating Systems	Windows, macOS, Linux
Print Resolution	1200 x 1200 dpi
First Print Out Time	8.2 seconds
Connectivity	USB 2.0
Maximum Monthly Duty Cycle	60000 pages
Recommended Monthly Page Volume	750 - 3, 500 pages
Scan Resolution	1200 x 1200 dpi
Copy Resolution	600 x 600 dpi
Media Sizes Supported	A4, A5, A6, B5, Letter, Legal
Media Types Supported	Plain, Thick, Thin, Cardstock, Label
Print Speed	33 ppm (A4) / 35 ppm (Letter)
Copy Speed	33 cpm (A4) / 35 cpm (Letter)
ADF Capacity	50 sheets
Paper Output Capacity	150 sheets