Pantum M7100 Series User Manual

5)
After completion of copying one side, put the paper into the entrance as shown in figure
(without turnover or rotation).
Note: ·If the turnover prompt on panel times out, the machine will execute one-sided
copying automatically.
6) Press "Start" to begin copying the other side.
8.4.9.Paper setting
Select the paper size and paper type of original copying in Paper Settings menu.
Note:
·
After “multipage” and “clone function” are set, “paper dimension”
supports “A4” and “Letter” only.
·
For copying with the ADF, only plain paper is available in "Paper Type".
For better copying effect, you can enter the “ID Card Copy Settings” menu to change relevant
settings.
1.
Press "ID
Card Copy" and then "Menu" on control panel to enter the "Menu Settings"
interface.
2.
Press "OK" to enter the "ID Card Copy Settings" interface.
3.
Press “direction key to select option to be set and press “OK key” to set option.
8.5. ID card copying setting
Paper dimension: A4, Letter, B5, A5, A6, Executive, Legal and Folio.
Paper type: common paper, thick paper, envelope paper, film paper, card paper, tagboard and
thin paper.
79

Pantum M7100 Series Specifications

General

Functionality	Print, Copy, Scan
Print Technology	Laser
Processor Speed	600 MHz
Memory	256 MB
Duplex Printing	Automatic
Scan Type	Flatbed, ADF
Fax Function	No
Paper Input Capacity	250 sheets
Supported Operating Systems	Windows, macOS, Linux
Print Resolution	1200 x 1200 dpi
First Print Out Time	8.2 seconds
Connectivity	USB 2.0
Maximum Monthly Duty Cycle	60000 pages
Recommended Monthly Page Volume	750 - 3, 500 pages
Scan Resolution	1200 x 1200 dpi
Copy Resolution	600 x 600 dpi
Media Sizes Supported	A4, A5, A6, B5, Letter, Legal
Media Types Supported	Plain, Thick, Thin, Cardstock, Label
Print Speed	33 ppm (A4) / 35 ppm (Letter)
Copy Speed	33 cpm (A4) / 35 cpm (Letter)
ADF Capacity	50 sheets
Paper Output Capacity	150 sheets