HS Consumer Treadmill
TROUBLESHOOTING GUIDE
Section 1
2
(1)
MCB
Error
Code
Error category When it happens. Follow up and send the information to Healthstream R&D center
Safety key Check Safety key If it happens frequently.
Check safety key cable and switch. - Open the plastic and check.
Next check the signal cable between motor and console.
Change the console.
Er 01 Speed sensor Speed sensor is broken.
Main power relay is
broken(in the motor
controller).
Motor is broken or motor
wire is badly connected.
PWM circuit that is in
console is broken.
Main cable is damaged.
Turn off and on the power.
Push Start key to test the treadmill.
Warning : Do not step on the treadmill, it is very dangerous.
1) Check if motor is running for short time.
if NO.
Check motor wire connection, motor brush connection, motor itself.
Motor controller circuit or signal cable was broken.
PWM circuit that is in console was broken.
if YES
Speed sensor wire connection , or speed sensor was broken.
Speed sensor circuit that is in motor controller was broken.
Signal cable or console was broken.
To Next Page
Loading...
