Paradigm T560 - Over Speed Error (Er 02); Memory Error (Er 06); Angle Switch Error (Er 08)

HS Consumer Treadmill
TROUBLESHOOTING GUIDE
Section 1
3
Error
Code
Error category When it happens. Follow up and send the information to Healthstream R&D center
Er 02 Over speed When treadmill runs faster
than target speed. - Check
Power circuit.
When User kicks the
treadmill belt faster
intentionally.
Frequency is very low.
It usually happens during
workout(14Km/h to
16Km/H).
Turn off and on the power.
Start the treadmill and check if there are Error 41 or others.
Warning : Do not step on the treadmill, it is very dangerous.
Er 06 Memory EEPROM of console error,
eeprom problem or circuit
problem.
Frequency is very low.
Turn off and on again. If it happens continually , you have to change the
console.
Er 08 Angle switch Angle switch broken.
When the treadmill is
folded.
When Err 08 on the console, even if treadmill is not folded.
Check the cable connection first and then check the angle switch(motor
control board).