HS Consumer Treadmill
TROUBLESHOOTING GUIDE
Section 1
4
Error
Code
Error category When it happens. Follow up and send the information to Healthstream R&D center
Er 15 Under speed When treadmill runs
slower than target speed.
Motor is damaged.
AC input is lower than
normal value(lower than
210VAC), with heavy user.
Deck and belt condition is
not good.(Check silicone).
Turn off and on the power.
Push Start key to test the treadmill.
Warning : Do not step on the treadmill, it is very dangerous.
During testing, if motor makes electric howling noise.
Check the motor condition and motor wires are tightly connected.
Check the condition of deck and belt, if deck and belt are damaged
you have to change the deck and belt , and lubricate it with silicone.
Er 05
Er 51
Er 52
Er 53
Elevation Check incline sensor or
motor.
Err 51,Err 52,Err 53
happen during self test or
calibration.
Turn off and on the power.
Calibrate the elevation motor again and check the console value.
Push and hole 12%+ 6% keys together for 2seconds to calibrate the motor.
Then treadmill goes up and goes down to the bottom, please check the
value on the monitor.
It should be more than 190 at the top, and it should be less than 40 at the
bottom.
Check the error message.
Er 51, Er 52, Er 53 or no message.
Check the elevation motor runs or not, when you test it ?
Warning : Do not step on the treadmill, it is very dangerous.
If no error message,
Please send the value that is displayed of the LCD during calibration to
Healthstream R&D center.
You have to do calibration again, if you want to use the elevation function.
To Next Page
Loading...
