1640 Icon LCD Keypad 27
6.0 Trouble List
Your alarm system continuously monitors fourteen possible
trouble conditions. Most of these trouble conditions can be
reported directly to your monitoring station.
We strongly suggest that you inform your monitoring
station of the trouble and allow them to service your
system.
The keypad can be programmed by the installer to emit a
beep every 5 seconds whenever a new trouble condition
has occurred. Press the key to stop the trouble beep.
When a trouble condition occurs, the icon will illuminate.
[1] No or Low Battery Trouble
The backup battery is disconnected or the battery voltage is
getting low.
[2] Wireless Transmitter Battery Low
The battery voltage in a wireless transmitter is low.
How Do I Access the Trouble List?
1. Press the key. The icon will flash and number(s)
corresponding to the trouble(s) will illuminate.
2. Read the corresponding explanation of the trouble from
the trouble list. If no repair instructions are given, call
your monitoring station for repairs.
3. Press the or the key to exit
1640-EU02.fm Page 27 Wednesday, May 18, 2005 3:10 PM
To Next Page
Loading...
Need help?
General
