10 Reference & Installation Manual
condition from the Trouble Groups occurs in the system. The
intermittent beep will remain activated until the user enters the
Trouble Display or if the trouble is resolved (see your control panel’s
Reference & Installation Manual for details concerning Trouble
Display). The intermittent beep will reinitialize whenever the trouble
reoccurs.
System Troubles / Clock Loss
Option [1] OFF = Disabled (default)
Option [1] ON = Enabled
Communicator Troubles
Option [2] OFF = Disabled (default)
Option [2] ON = Enabled
Module / Combus Troubles
Option [3] OFF = Disabled (default)
Option [3] ON = Enabled
Zone Troubles
Option [4] OFF = Disabled (default)
Option [4] ON = Enabled
4.9 Keypad Anti-Tamper Enable
Section [011]: Option [5]
When the option [5] is enabled and the keypad's anti-tamper switch
is triggered, the keypad will send a tamper report to the control panel
via the combus. For information on how the control panel will process
the tamper, refer to the tamper recognition options in your control
panel’s Reference and Installation Manual.
Option [5] OFF = Keypad's anti-tamper is disabled (default)
Option [5] ON = Keypad's anti-tamper is enabled
DGP2640_EI00.fm Page 10 Thursday, April 7, 2005 12:05 PM
To Next Page
Loading...
Need help?
General
