DGP2-640 Icon LCD Keypad 13
5.6 PGM Deactivation
Sections [018] to [021]
Modules belonging to the DGP2 series are programmed using the
PGM Programming table in the Digiplex Modules’ Programming
Guide. If the PGM Deactivation Option is set to follow the PGM
Deactivation Event, the PGM will return to its normal state when the
event programmed in sections [018] to [021] occurs. The Event
Group specifies the event, the Feature Group identifies the source
and the Start # and End # set the range within the Feature Group.
Use the PGM Programming Table in the Digiplex Modules’
Programming Guide to program the keypad’s PGM Deactivation
Event.
Enter the sections that correspond to the Event Group, Feature
Group, Start # and End # of the PGM and enter the required data.
5.7 PGM Test
Section [030]
Use this section to initiate a PGM test, which will activate the PGM
for 8 seconds. Enter section [030] to activate this test.
Event Group Feature Group Start # End #
PGM [018] __/__/__ [019]__/__/__ [020]__/__/__ [021]__/__/__
DGP2640_EI00.fm Page 13 Thursday, April 7, 2005 12:05 PM
To Next Page
Loading...
Need help?
General
