DGP2-640 Icon LCD Keypad 5
[0000] (DGP-NE96) in Step 3 to view the keypad’s serial number.
When entering the serial number, the S and T icons on the right
side of the screen will illuminate and you can use the [S] and [T]
keys to scroll through the serial number.
3.2 Programming Methods
The following methods can be used when programming the keypad:
3.2.1 Feature Select Programming
Some sections are programmed by enabling or disabling
options. Within the sections, numbers from [1] to [8] represent
a specific keypad option. Press the key corresponding to the
desired option and the digit will appear in the display. This
means the option is enabled. Press the key again to remove
the digit from the display thereby disabling the option. Press
the key when options are set.
3.2.2 Decimal Programming
Some sections require that a decimal value be entered. In this
method, any digit from 000 to 255 can be entered.
3.3 Module Broadcast
The control panel’s Module Broadcast feature can be used to copy
the contents of one keypad to one or more keypads.
1. From Normal Mode press and hold the [0] key.
2. Enter the [
INSTALLER CODE] (default: 000000).
3. Enter section [954] (DGP-848) / [4004] (DGP-NE96).
4. Enter the [
SERIAL #] of the source keypad. The source is the
programmed keypad whose data you want to copy to other
keypads. When entering the serial number, the S and T icons
on the right side of the screen will illuminate and you can use
the [S] and [T] keys to scroll through the serial number.
5. Enter the [
SERIAL #] of the destination keypad(s). The
DGP2640_EI00.fm Page 5 Thursday, April 7, 2005 12:05 PM
To Next Page
Loading...
Need help?
General
