8 Reference & Installation Manual
other keypads.
5. E nt er the [SERIAL #] of the destination keypads. The
destination is the keypad(s) you want to program with the
source’s data. If you want to program more than one
keypad with the source’s data, enter the serial numbers
of the keypads one at a time.
6. O nc e yo u ha ve e n te red th e se rial numb ers o f t he
keypads you want to program, press the [ACC] key.
3.4 Memory Key
SECTIONS [510] AND [520]
Download information to and from an LCD keypad using the
memory key (PMC-3).
Only the PMC-3 memory key will function with the
LCD keypad.
3.5 Download Contents of Memory Key to Keypad
SECTION [510]
1. Insert the memory key into the keypad’s connec tor
labelled “KE Y” (refer to Figure 2.1 on page 5).
2. To download the contents of the memory key, enter the
Section [510] = Download all from the memory key (LCD
keypad s ections [001] to [396] and all
messages) to the LCD keypad.
Section [520] = Copy the LCD keypad sections [001] to [396]
and all messages to the memory key.
To Next Page
Loading...
Need help?
General
