Paradox Digiplex NE DGP2-641 - Tamper Detection and Bus Monitoring

Digiplex/DigiplexNE LCD Keypad 15n
4.12 Key pa d Tam per E nable
SECTION [006]: O PT ION [5]
When tamper is enabled and the keypad's on-board anti-tamper
switch is triggered, the keypad will send a Tamper report to the
control panel via the communication bus.
4.13 Communication Bus Voltmeter
The Communication Bus Voltmeter provides a real-time display
of the voltage so you can verify if the bus is supplying sufficient
power at the keypad’s location. The readings will appear on the
LCD screen. A reading of 10.5V indicates that the voltage is too
low. This may occur when too many modules are connected to
the bus, a module is installed too far from the panel or if the
Option [2] OFF = Beep disabled: Communicator Troubles
(default).
Option [2] ON = Beep enabled: Com municator Troubles.
Option [3] OFF = Beep disabled: Module and Bus Troubles
(default).
Option [3] ON = Beep enabled: Module and Bus Troubles.
Option [4] OFF = Beep disabled: all Zone Troubles (default).
Option [4] ON = Beep enabled: all Zone Troubles.
Option [5] OFF = Keypad's tamper is disabled (default).
Option [5] ON = Keypad's tamper is enabled.