Digiplex/DigiplexNE LCD Keypad 7n
case it will erase the current data entry. Please note that the
se ria l n u mb er is lo ca te d o n the ke yp ad ' s P C boa rd or en te r
section [000] in Step 3 to view the keypad’s serial number.
3.2 Programming Methods
The following methods can be used when programming the
keypad:
3.2.1 Feature Select Programming
Some sections are programmed by enabling or disabling
options. Within the sections, numbers from [1] to [8 ]
represent a specific keypad option. Press the key
corresponding to the desired option and the digit will
appear in the display. This means the option is enabled.
Press the key again to remove the digit from the display
thereby disabling the option. Press [ENTER] when options
are set.
3.2.2 Decimal Programming
Some sections require that a decimal value be entered. In
this method, any digit from 000 to 255 can be entered.
3.3 Module Broadcast
The control panel’s Module Broadcast feature can be used to
copy the contents of one keypad to one or more keypads.
1. From Normal Mode press and hold the [0] key.
2. E nt er [INSTALLE R CODE] (default: 000000).
3. Ent er section [954] (DGP-48) / [4004] (DGP-NE96).
4. E nt er the [SERIAL #] of the source keypad. The source is
the programmed keypad whose data you want to copy to
To Next Page
Loading...
Need help?
General
