Digiplex/DigiplexNE LCD Keypad 19n
value (000 to 255) in section [008]. The 3-digit value will be
multiplied by the PGM Base Time of 1 second or 1 minute (see
section 5.3 above). Default: 5 seconds.
5.6 PGM Ac tivation Ev ent
SECTIONS [009] TO [012]
The PGM Activation Event determines which event will activate
the keypad's on-board PGM output. The EVENT GRO UP specifies
the event, the FEAT URE GROUP identifies the source, and the
START # and END # sets the range within the Feature Group. Use
the PGM Programming Table in the Digiplex/Digiplex NE
Modules’ Programming Guide to program the keypad’s PGM
Activation Event.
Enter the sections that correspond to the EVENT GRO UP, FEATURE
GROUP, START # and END # of the PGM and enter the required
da ta .
5.7 PGM De activa tion Eve nt
SECTIONS [013] TO [016]
If the PGM Deactivation Option (section section 5.2 on page 17
on page 17) is set to follo w th e P G M Deactivation event, the
PGM will return to its normal state when the event programmed
in sections [013] to [016] occurs. The EVENT GRO UP specifies the
ev en t , t he FEATURE GROUP identifies the source, and the START #
and END # sets the range within the Feature Group. Use the PGM
Even t Group Feature Gr oup Start # En d #
PGM [009] [010] [011] [012]
To Next Page
Loading...
