PAGE 12 Imperial System Programming
Firmware Upgrade
Imperial Systems
The K07C is firmware upgradeable remotely via the V32 controller’s
Multibus at 57.6Kbps. Using BabyWare connect to the V32 account
using any of the connection methods (direct connect, IP static, or IP
DNS). Right-click the desired module and select Upgrade. When
communicating through the Internet, BabyWare will indicate whether
the panel or any of the bus modules have a newer firmware version
available. A firmware upgrade for a single module or group of
modules will take usually less than 10 minutes, which keeps system
downtime to a minimum.
EVO/DGP Systems
Upgrade Grafica’s firmware version using the 307USB Direct
Connect Interface (see 4-pin connection in Figure 10 on page 11)
and In-Field Paradox Upgrade Software. For firmware upgrade
instructions, go to paradox.com > Software >WinLoad, and locate the
Firmware Upgrade Instructions document.
NOTE: You must first disconnect the keypad’s GRN and YEL
combus wires before following instructions.
Chapter 3: Imperial System Programming
For Imperial systems, all Grafica programming and options are set using
BabyWare software. For more information, refer to the BabyWare
instructions in the Imperial System Guide.
NOTE: Floor plans, tones and graphics can be downloaded to Grafica
using BabyWare.
Chapter 4: EVO/DGP System Programming
For EVO and DGP systems, Grafica programming is done through the
panel’s Module Programming Mode. Grafica can also be programmed
using the WinLoad Installer Upload/Download Software. For more
information, refer to the WinLoad instructions or visit our Web site at
www.paradox.com. We strongly recommend that you read this entire
manual before you begin programming.
NOTE: Floor plans, tones and graphics can be downloaded to Grafica
using WinLoad V2.6 or higher and NEware V2.0 or higher.
To Next Page
Loading...
Need help?
General
