PAGE 14 EVO/DGP System Programming
Keypad Options
The following sections detail Grafica’s programing options for EVO/DGP
systems.
Partition Assignment
SECTION [001]: OPTIONS [1] TO [8]
Each keypad in the system can be assigned to one or more
partitions. In section [001], options [1] to [8] represent partitions 1
through 8 respectively. To assign the keypad to a partition, enable the
option that corresponds to the desired partition. By default, partitions
1 to 8 are enabled.
NOTE: Options [5] to [8] are not available with DGP-848 systems.
Display Code Entry
SECTION [002]: OPTION [1]
This option determines whether the user’s code # (PIN) is displayed
on the LCD screen when entering the PIN.
Option [1] OFF = Digits are replaced by asterisks (*) (default)
Option [1] ON = Code # (PIN) digits will be displayed
Display Exit Delay
SECTION [002]: OPTION [2]
Based on the user's needs, an Exit Delay Timer can be programmed
to provide the user time to exit the partition before the system is
armed. If this option is enabled, the Exit Delay Timer's countdown will
appear on the LCD screen next to the hourglass icon.
Option [2] OFF = Exit delay time will not appear
Option [2] ON = Exit delay time will appear (default)
Display Entry Delay
SECTION [002]: OPTION [3]
Based on the user's needs, an Entry Delay Timer can be
programmed to provide the user time to enter their code # (PIN)
before the alarm is triggered. If this option is enabled, the Entry Delay
Timer's countdown will appear on the graphic LCD screen next to the
hourglass icon.
Option [3] OFF = Does not display Entry Delay Timer
Option [3] ON = Displays Entry Delay Timer (default)
To Next Page
Loading...
Need help?
General
