MG6250 Console • User Guide
Chapter 3 - Arming and Disarming | 19
Bypassing Zones
Bypassing a zone allows you to ignore (deactivate) specified zones the next time the system is armed. You
can bypass certain zones when you arm the system. When a zone is bypassed, it will be ignored the next time
you arm the system. Once the system is disarmed, they system will unbypass the zone. Zones that can be
bypassed are defined by your installer. For more information on how to bypass zones, refer to section
Bypassing Zones on page 25.
NOTE: Fire zones cannot be bypassed. For more information on fire zones, refer to Fire Alarms on page 57.
Auto-Arming
You can set the time that the system will arm itself automatically. There are two methods of auto-arming,
they include timed auto-arming and no movement auto-arming.
NOTE: Auto-arming is not permitted in UL installation. To find out if your system is installed under UL
requirements, contact your service provider.
Timed Auto-Arming
Your installer can set the timed auto-arming method to function in either Regular or Stay arming modes. A
60-second exit delay sequence will begin prior to your system automatically arming itself at the programmed
time. Contact your installer for more information.
To Next Page
Loading...
Need help?
General
