MG6250 Console • User Guide
20 | Chapter 3 - Arming and Disarming
No Movement Auto-Arming
Your system can be programmed to send a report to your monitoring station and arm the system if there is
no activity, during a specified period of time. Your installer can set no movement auto-arming to function in
either Regular or Stay arming modes. Talk to your installer for more information.
Disarming
When your system is disarmed, it deactivates any alarms in progress as well as zones, therefore, an alarm will
not be triggered if zones are breached.
Entry Delay Timer
Your installer will program designated entry points (e.g., the front door) with an Entry Delay timer. This delay
gives you time to enter the armed premises and enter your user code to disarm your system before the alarm
is triggered. Up to two entry delay timers can be programmed in your MG6250 console. For more information
on how to program the entry delay timer, refer to Chapter 5 - System Setup on page 35.
NOTE: UL installations require a maximum entry delay of 45 seconds. To find out if your system is installed
under UL requirements, contact your service provider.
Disarming an Armed System
When an entry point, like the front door, is opened, the MG6250 console will produce a sound indicating that
the system has started the entry delay timer. If a valid user code is entered before the entry delay elapses,
your system will disarm and will not generate an alarm.
To Previous Page
Loading...
Need help?
General
