Paradox R885S

R885S 9
SYSTEM PROGRAMMING
The Installer Code (default: 000000) can
program a new Installer Code PIN in section
[200] and program all the system sections from
[001] to [005] and [101] to [104].
To Enter System Programming Mode:
1. Press and hold the [
CLEAR] key for 4 seconds.
The reader emits a confirmation beep, the
green LED turns ON and the red LED turns
OFF.
2. Enter the [
INSTALLER CODE] and press the
[
ENTER] key.
Reader emits a confirmation beep and the
green LED flashes.
3. Enter the 3-digit [
SECTION] and press the
[
ENTER] key.
Reader emits a confirmation beep and green
LED becomes constant.
4. Enter the required [
DATA] and press the
[
ENTER] key.
The reader emits a confirmation beep and the
green LED flashes.
Note: It may take several seconds for the
module to register the command and emit a
confirmation beep.
5. To program another section, repeat steps
3 and 4. To exit, press and hold the [
CLEAR]
key for 4 seconds.
The reader emits a rejection beep and the
green LED turns OFF.