20 Installation and Operating Instructions
previously been programmed with a PIN/card.
If the red LED is ON, the user code is free.
5. Press the [
CLEAR] key.
The red LED flashes.
6. Press the [
ENTER] key to confirm the removal
and advance to the next section.
To exit:
•Press [
CLEAR] key. The red and green LEDs
will flash alternately.
• Press the [
CLEAR] key a second time. Both
LEDs will flash simultaneously.
• Press and hold the [
CLEAR] key a third time
to exit this section.
SECTION [204] USER CODE RESET
User Code Reset is used to delete all the User
Codes (from User Code 000 to 999).
To Reset all User Codes:
1. Press and hold the [
CLEAR] key for 4 seconds.
The reader emits a confirmation beep, the
green LED turns ON and the red LED turns
OFF.
2. Enter [
MASTER CODE 1 or MASTER CODE 2] and
press the [
ENTER] key.
Reader emits a confirmation beep and the red
and the green LEDs flash simultaneously.
3. Enter [204] and press the [
ENTER] key.
Reader emits a confirmation beep, the green
LED turns ON and the red LED turns OFF.
4. Press the [1] key and then press the [
ENTER]
key to confirm the reset.
To Next Page
Loading...
General