R885S 19
When you press the [CLEAR] key in step 5:
If the User Code is not programmed, the
R885S will revert to step 4. If a card or PIN
was entered, press the [
Enter] key to
confirm the removal and advance to the
next user code or press the [
CLEAR] key to
enter a new user code. If you press and
hold the [
CLEAR] key you will exit this
section entirely.
DELETING A USER CODE
User Codes can be deleted individually. When the
User Code is deleted, a new card and/or PIN can
be programmed in the section.
To Delete User Codes:
1. Press and hold the [
CLEAR] key for 4 seconds.
The reader emits a confirmation beep, the
green LED turns ON and the red LED turns
OFF.
2. Enter [
MASTER CODE 1 or MASTER CODE 2] and
press the [
ENTER] key.
Reader emits a confirmation beep and the red
and the green LEDs flash simultaneously.
3. Enter [203] and press the [
ENTER] key.
Reader emits a confirmation beep and the red
and the green LEDs flash alternately.
4. Enter the 3-digit User Code (not the user’s
PIN) that you wish to delete. Press the
[
ENTER] key.
The reader emits a confirmation beep and the
green LED turns ON. The red LED should be
OFF, indicating that the user code has
To Next Page
Loading...
General