R885S 17
The reader emits a confirmation beep and both
LEDs flash.
5. To exit, press and hold the [
CLEAR] key for 4
seconds.
The reader emits a rejection beep and the
green LED turns OFF.
SECTION [203] USER CODE PROGRAMMING
Master Code 1 and 2 can activate cards and
program the personal identification numbers
(PIN) for the User Codes. The R885S includes
1000 User Codes. User Code 000 to 999 can be
1 to 8 digits in length where each digit can be any
value from 0 to 9. You can use the table on
page 24 to record the User Codes.
To Program User Codes:
1. Press and hold the [
CLEAR] key for 4 seconds.
The reader emits a confirmation beep, the
green LED turns ON and the red LED turns
OFF.
2. Enter [
MASTER CODE 1 or MASTER CODE 2] and
press the [
ENTER] key.
Reader emits a confirmation beep and the red
and the green LEDs flash simultaneously.
3. Enter [203] and press the [
ENTER] key.
Reader emits a confirmation beep and the red
and the green LEDs flash alternately.
4. Enter the number of the desired User Code.
Press the [
ENTER] key.
The reader emits a confirmation beep and the
green LED turns ON. If the red LED turns ON,
To Next Page
Loading...
General