16 Installation and Operating Instructions
MASTER PROGRAMMING
Master Programming Mode is used to program
Master and User Codes.
SECTIONS [201] AND [202] CHANGING THE
MASTER CODES
Master Code 1 (default: 111111) is used to
program both Master Codes, the User Codes and
the Section [002] Door Lock Control (see
page 10). Master Code 2 (default: 222222) can
program the User Codes and change its own PIN.
Master Code 2 cannot program Master Code 1 or
the Door Lock Control. In the desired section
enter the 6-digit personal identification number
(PIN) where each digit can be any value from 0 to
9.
To Change the Master Codes:
1. Press and hold the [
CLEAR] key for 4 seconds.
The reader emits a confirmation beep, the
green LED turns ON and the red LED turns
OFF.
2. Enter [
MASTER CODE 1 or MASTER CODE 2] and
press the [
ENTER] key.
Reader emits a confirmation beep and the red
and the green LEDs flash simultaneously.
3. Enter [201] to change Master Code 1 or
[202] to change Master Code 2 and press the
[
ENTER] key.
Reader emits a confirmation beep and the
green LED becomes constant.
4. Enter the new PIN and press the [
ENTER] key.
To Next Page
Loading...
General