18 Installation and Operating Instructions
the section is empty. If the red LED stays OFF,
a User Code is already programmed in the
section.
5. Program the card, access code (or both
combined) according to the option selected in
section [001] (see page 9). Then enable one of
the following options:
• Reader only: present the card to the reader
without pressing the [
ENTER] key. The reader
will automatically advance to the next User
Code.
• Keypad only (PIN is less than 8 digits): enter
PIN and press the [
ENTER] key to advance to
the next User Code.
• Keypad only (PIN is more than 8 digits):
enter PIN, the reader will automatically
advance to the next User Code after you
have entered the 8th digit.
• Keypad and reader: present the card to the
reader followed by the PIN. Press the
[
ENTER] key to advance to the next User
Code.
6. The reader automatically advances to the next
sequential user position. Return to step 5 to
program another card.
To e xit:
•Press [
CLEAR] key. The red and green LEDs
will flash alternately.
• Press the [
CLEAR] key a second time. Both
LEDs will flash simultaneously.
• Press and hold the [
CLEAR] key a third time
to exit this section.
To Next Page
Loading...
General